Network interfaces

This section describes the network interfaces that you connect the different types of network traffic to. The network bandwidth requirements for the different types of traffic are usually not the same. The different types of network traffic are:

  • Management
  • Viewing
  • Camera
  • Storage

Connectors

The table below helps you choose the right network interface for the different types of network traffic. The LED status indicators can help check if the wanted network link speed is established.

Connectors Description
1. LAN port 1 (1Gb/s) Connect your local area network with connection to the internet, if available. This network is for management and viewing.
2. LAN port 2 (1Gb/s)

Connect your camera network or

Connect your network for viewing if your unit is equipped with a PoE+ network switch

3. PoE+ network switch 16 x 1Gb/s (Option)

Connect your cameras or

Connect other devices powered by PoE

LED status indicators LED colors Description
4. LAN ports activity Flashing yellow Actively transmitting or receiving packets
5. LAN ports link speed

Green

Yellow

Off

1Gb/s

100Mb/s

10Mb/s

6. PoE switch LAN ports activity Flashing yellow Actively transmitting or receiving packets
7. PoE switch LAN ports power delivery

Green

Red

Power delivery OK

Power delivery failure

Troubleshoot a network interface

  1. Check the status indicators on the LAN port or the PoE switch LAN port:
    • If the link speed indicator does not light up, check all cable connections
    • If the activity indicator does not light up, the network driver files might be damaged or missing. Remove and reinstall the drivers if applicable.
    • Use another connector on the switch or hub

    Use Husky Switch Manager to get detailed status information on a specific PoE switch LAN port.

  2. In Windows 10, go to Network status > Change adapter options to check that the LAN ports are enabled and connected.
  3. Make sure that the LAN ports and switches on the network are all set to the same data transmission speed and duplex. For more information, see the documentation for each network device.
  4. Make sure that all network cables are of the proper type and that the cables do not exceed the maximum length.

    If all troubleshooting fails, contact your Milestone reseller.